Shop gets a makeover - with a new floor "in a jiffy"

Read Mr. Daron Wild's blog when he installed Bergo Unique in his shop

 

Source reference: Blog 2021-01-18  https://www.korfi.co.uk/bergo-unique-floor-tile/

Bergo Unique Floor Tile

 17/01/2021  

It’s been a while since I last posted anything here. The shop floor is at the stage where I need to consider flooring.

The bay windows have now been boxed in and the electric cabinet finished.


I wanted something that I could lay myself, and be able to remove it easily. 

But the wooden floor I have is very uneven. These tiles interlink like a jigsaw puzzle piece, but I found the edges would not lay flat, even with underlay beneath them. This would cause a trip hazzard. They also have the potential to expand under direct sunlight. The huge shop windows act like a greenhouse in the summer, so I ruled these out.

I finally went with Bergo Unique tiles in charcoal grey. These are smaller but have a much better design for joining.


I didn’t get any samples of these. The manufacturer assured me they would be perfect for my uneven floor.

The instructions say to start in a corner but all their examples are based on a perfectly square floor. My room has funny angles on all four walls so I experimented by loose laying to get a feel of the best cuts.


I decided to keep it level with the floorboard run, which would mean both sides would have tapered cuts at the edges.


The whole tiles go down very fast. The edges take longer as I cut them with a jigsaw. I did also buy perimeter edging but I found I didn’t need to use it.


At this point I wanted to provide a channel across the floor whereby I could supply power to the shop counters if I needed to.


They have to extend across the entire floor otherwise the tiles would be out of line. But it looks very neat.


I’m sure keeping these clean is going to be a pain!


I was worried that the tapered edges would look odd, but with them all down it is fine.

I have started putting in the shop counters, but they are all flat-pack so taking a while.

In summary then I can recommend these Bergo Tiles. Good quality, easy to cut and fit.

I will update this in 6 months time to see how they faired with people walking all over them and the impact of sun/expansion. And of course how easy it was to keep them clean!

 

Post navigation

← Final Shop Floor spec

2 thoughts on “Bergo Unique Floor Tile”

  1. Stuart Dwightsays:

17/01/2021 at 22:42

Great job Daron. It’s looking really good now. Are they easy to take one up?

  1. ChuckyDollsays:

18/01/2021 at 08:20

Yes, I have a special tool that can pry them out without damaging them.

Back to top